ASTM D and AATCC Test Method Colorfastness to Solvent measures the resistance of solvent of dyed, printed, or otherwise colored textile yarns. Subscribe to RSS – ASTM D © Copyright Burch. All rights reserved. Terms and Conditions of Sale | Proposition 65 Warnings · About | Contact | Grand. (ASTM). Herman Miller strives to meet and exceed all industry standards pertaining to our Tunnel Test – ASTM E 84 Seam Slippage ASTM D D
|Genre:||Health and Food|
|Published (Last):||14 October 2010|
|PDF File Size:||15.80 Mb|
|ePub File Size:||2.78 Mb|
|Price:||Free* [*Free Regsitration Required]|
Referenced Documents purchase separately The documents listed below are referenced within awtm subject standard but are not provided as part of the standard. The number of pounds of pressure required to separate the sewn seam determines the rating. Ratings are determined by the percentage of fabric’s surface affected by fungal activity. This performance specification covers the performance requirements for plain, tufted, or flocked woven upholstery fabrics as used in the manufacture of new indoor furniture.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Flame Spread Index of 25 or less and Smoke Developed value of or less.
These listings are intended as a reference only. The sewn fabric is then clamped at opposing side of the seam. Link to Active This link will always route to the current Active version of the standard. This test is performed in both the warp and filling directions.
Historical Version s – view previous versions of standard. These requirements apply to both the warp and filling directions for those factors where each fabric direction is pertinent.
ASTM D3597 – 02(2013)
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Check r3597 the firm from which you purchased the fabric. Fiber reactive dyes will only be used in cotton.
Measures the maximum force applied to a material to d357 a rupture. Rating System for Regular Surface Effect: These codes vary per location and application. Minimum Panels and Upholstered Walls: This method is utilized for materials not ultimately glued to a surface.
This test utilizes nylon bristles to rub the surface of the test fabric for a specific amount of time. Duralee Duralee Duralee Contract B.
Weights are used on test We qstm be able to accommodate you. The number of pounds required to cause separation due to yarn slippage determines the rating.
It is important to remember that non water durable dyes may bleed or fade when subjected to this wet finishing process. Measures the ability of a sewn seam to resist slippage or astmm when subjected to tension. Acceptance Criteria for warp and fill Upholstery: Select substrate to adhere the specimen according to the end use.
Measures mass loss, expressed as a percent and drip burn.
Industry Specifications & Tests – Duralee
Casements shrink much more. It is essential that the post processor be alerted when a fiber reactive dye has been used so that the fabric can be properly treated. No appreciable wear after 15, double rubs No appreciable wear after 30, double rubs Appreciable wear at fewer than 15, double rubs. If a treated fiber reactive dyed fabric is exposed to asm right amount of light, heat and humidity for a period of time the color will change, and in some cases, drastically.
Measures the ignition resistance of a slightly restrained specimen when exposed to a very v3597 flame. Cellulose fibers such as cotton and linen are easily treated because they readily absorb moisture.